The CRM 7-driven Crowning (see photo on left) makes it possible to horizontally insert and remove bottom tools from both sides. The CRM 7 is installed on the right-hand side of the Crowning as standard. This motor is fitted on all New Standard Pro Crowning (NSCR-I) with a length up to 4,250 mm. The existing CRM 12 will be used for lengths in excess of 4,250 mm.
The CRM 7 motor is available in the following voltages (EU: 400V/50Hz, 230V/50Hz) (Optionally, Pro Crowning systems can also be fitted with the
CRM 14-K motor, mounted at the side. Please see section 'CRM 14-K' below).
CRM 14The CRM 14 is a tubular motor that is standard on all New Standard
Premium Crowning (NSCR-II) with a length up to 6,120 mm. The existing
CRM 12 will be used for lengths in excess of 6,120 mm. This motor also
remains available (optional) for shorter lengths.
The main
benefit of this CMR 14 motor is, besides better accuracy and higher
speed, the ability to implement an angle measuring system. Rails can be
placed at the front as well as the back. The CRM 14 is available in two
different options: CRM 14-I and CRM 14-K.
CRM 14-IThe
CRM 14-I tubular motor is built into the lower beam if a minimum width
of 90 mm is available. The main benefit of this integrated motor (CRM
14-I) is that it is located entirely inside or under the lower beam,
thus offering perfect bending freedom at both edges. In the same way as
the above mentioned CRM 7 motor, it is also possible to insert and
remove tools horizontally from both sides. The CRM 14-I motor is
available in the following voltage 400 V-50 Hz
.
CRM 14-KThe
CRM 14-K tubular motor is built at the right side of the table. It will
still be possible to insert and remove tools horizontally in this
version. The CRM 14-K is available in the following voltage 400 V-50 Hz.
Factsheet
Motors |
CRM 12
|
CRM 7
|
CRM 14-K
|
CRM 14-I
|
Inbuilt? |
No |
No
|
No
|
Yes
|
Horizontal tools? CR-I
|
No |
Yes |
Yes |
Yes |
Horizontal tools? CR-II
|
No
|
n/a
|
Yes |
Yes |
Possible to use linear Angle measurementsystem? |
No |
No
|
Yes |
Yes |
Minimum lower beam width
|
n/a |
n/a |
n/a |
90mm |
Speed (mm/s) |
4,7
|
3,3 |
7,7 |
7,7 |
Operating time (10°C-30°C) |
S3-40%
|
S3-30%
|
S3-40%
|
S3-40%
|
Reading
|
Potentio meter
|
Potentio meter
|
Potentio meter |
Potentio meter |
Plug
|
Yes |
No |
No
|
No
|
Brake
|
Yes
|
No
|
Yes |
Yes |